Supermicro X13SRA-TF - Page 69

69
Chapter 2: Installation
1. Watchdog (JWD1)
2. USB6/7 Standby Power (JPUSB1)
Watchdog
Watchdog (JWD1) is a system monitor that can reboot the system when a software application
hangs. Close pins 1-2 to reset the system if an application hangs. Close pins 2-3 to generate
a non-maskable interrupt (NMI) signal for the application that hangs. Refer to the table below
for jumper settings. For this function to work properly, please also enable the Watchdog
setting in the BIOS.
Watchdog
Jumper Settings
Jumper Setting Denition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
USB6/7 Standby Power
JPUSB1 allows you to enable or disable the USB6/7 power in S5 standby mode. The default
is on pins 1-2 to enable USB6/7 power in S5 standby mode. Refer to the table below for
jumper settings.
USB6/7 Standy Power Enable/Disable
Jumper Settings
Jumper Setting Denition
Pins 1-2 Enabled (Default)
Pins 2-3 Disable
BAR CODE BAR CODE
IPMI CODE
MAC CODE MAC CODE SAS CODE
JTPM1
SP1
USB9 (3.2)
(USB3.2 GEN2X2)
UID-LED
JPI2C1
M.2-C01 LED
M.2-C02 LED
JF1
JWD1
JPL1
JPUSB1
JPL2
JSD1
FAN2
HD AUDIO
AUDIO FP
JUIDB1
LED8
COM1
USB0/1
FANB
FANC
BATTERY
DIMME2 DIMMF2 DIMMF1 DIMME1
DIMMA2 DIMMA1 DIMMB2 DIMMB1
SATA 1
SATA 0
SATA 3
SATA 2
SATA 4
SATA 5
M.2-C01
M.2-C02
JPME2
JL1
JRK1
(RAID Key Header)
JCMOS
JBT1
JPW2
JPW3
FAN1
FANA
JSTBY1
CPU SLOT6 PCIe 5.0 X16
JOH1
JPW1
12V_ PUMP_PWR1
USB8
(USB3.2 GEN2X2)
VGA
CPU SLOT4 PCIe 5.0 X16
PCH SLOT1 PCIe 4.0 X4
CPU SLOT2 PCIe 5.0 X16
BMC LED
JSPDIF_OUT
JPAC1
CPU
PCH
BIOS LICENSE
LAN
CTRL
BMC
USB6/7
(USB3.2 GEN2)
LAN1
USB4/5
(USB3.2 GEN2)
LAN2
Power LED
(PCIe 5.0 X4)
(PCIe 5.0 X4)
X13SRA-TF
DESIGNED IN USA
REV:1.01
JD1
(SPEAKER 1-4)
USB2/3 (3.0)
(USB3.2 GEN1)
LAN
CTRL
1
2