Supermicro X13SRA-TF - Page 92

Super X13SRA-TF User's Manual
92
LLC Dead Line Alloc
Select Enable to opportunistically ll the dead lines in the LLC. The options are Disable,
Enable, and Auto.
Memory Conguration
This feature allows you to congure the Integrated Memory Controller (iMC) settings.
Enforce DDR Memory Frequency POR
Select POR to enforce Plan of Record (POR) restrictions for DDR memory frequency
and voltage programming. The options are POR and Disable.
Memory Frequency
Use this feature to set the maximum memory frequency for onboard memory modules.
The options are Auto, 3200, 3600, 4000, 4400, 4800, 5200, and 5600. Please note that
the available options are CPU dependent.
Data Scrambling for DDR5
Select Enable to enable data scrambling for DDR5 modules to enhance memory data
security. The options are Disable and Enable.
DDR 2X Refresh Enable
Select Enable for memory 2X refresh support to enhance memory performance. The
options are Auto, Disable, and Enable.
Memory Topology
This feature displays the information of onboard memory modules as detected by the
BIOS, for example:
P1-DIMMA1: 4800MT/s Hynix DRx8 32GB RDIMM
Memory RAS Conguration
Use this submenu to congure the following Memory Reliability_Availability_Service-
ability (RAS) settings.
Mirror Mode (Available when "ADDDC Sparing" is set to Disabled)
Use this feature to congure the mirror mode settings for all 1LM/2LM memory mod-
ules in the system which will create a duplicate copy of data stored in the memory to
increase memory security, but it will reduce the memory capacity into half. The options
are Disabled and Full Mirror Mode.