Supermicro X13SRA-TF - Page 98

Super X13SRA-TF User's Manual
98
IIO eDPC Interrupt (Available when your system supports this feature and when
"IIO eDPC Support" is set to On Fatal Error/On Fatal and Non-Fatal Errors)
Select Enable to enable IIO eDPC Interrupt support. The options are Enable and Disable.
IIO eDPC ERR_COR Message (Available when your system supports this feature
and when "IIO eDPC Support" is set to On Fatal Error/On Fatal and Non-Fatal
Errors)
If this feature is set to Enable, an IIO eDPC error correction message will be displayed.
The options are Enable and Disable.
South Bridge
The following information is displayed:
• USB Devices:
XHCI Hand-o󰀨
This is a work-around solution for operating systems that do not support Extensible Host
Controller Interface (XHCI) hand-o󰀨. The XHCI ownership change should be claimed by
the XHCI driver. The options are Enabled and Disabled.
Port 60/64 Emulation
Select Enabled for I/O port 60h/64h emulation support, which in turn, provides complete
legacy USB keyboard support for the operating systems that do not support legacy USB
devices. The options are Disabled and Enabled.
PCI Express Conguration
DMI Link ASPM Control
Use this feature to set the Active State Power Management (ASPM) state on the System
Agent (SA) side of the DMI Link. The options are Disabled and L1.
Peer Memory Write Enable
Use this feature to enable or disable peer memory write. The options are Disabled and
Enabled.
PCH SLOT1 PCIEe 4.0 X4
ASPM
Use this feature to activate the Active State Power Management (ASPM) level for a
PCI-E device. Select Auto for the system BIOS to automatically set the ASPM level
based on the system conguration. Select Disabled to disable ASPM support. The
options are Disabled and L1.