Supermicro X7SBi - Jumper Settings; Explanation of Jumpers; GLAN Enable;Disable

Chapter 2: Installation
2-21
200
4
ITE
IDE CTRL
Battery
Super I/O
Slot1 PCI 33 MHz
Slot6 SXB2 PCI-X 133 MHz
Slot6 SXB1 PCI-Exp. x8
JBT1
JPG1
ATI
ES1000
VGA
CTRL
JPL1
Intel
LAN
CTRL
Buzzer
Intel
LAN
CTRL
BIOS
KB/MS
USB0/1
COM1
VGA
LAN1
LAN2
Fan6
ATX 24-Pin PWR
CPU Fan
SMB PS
Fan1
8-Pin PWR
CPU
MCH
Intel 3210
Xeon
3000/3200
DIMM1A
DIMM1B
DIMM2A
DIMM2B
Fan 5
JLED1
LE1
JOH
Fan2
Fan3
JL1
JWD
Speaker
IDE
Floppy
Fan4
SATA0
SATA1
SATA2
SATA3
SATA4
SATA5
JWOL
JI
2
C1
JI
2
C2
COM2
Printer
SIMSO (IPMI 2.0)
JPL2
Intel ICH9R
PXH-V
USB8/9 USB6/7
FP USB10
FP USB11
FP CTRL
JUSB1
JWOR
JPUSB2
T-SGPIO2
T-SGPIO1
X7SBi
2-7 Jumper Settings
Explanation of
Jumpers
To modify the operation of the motherboard,
jumpers can be used to choose between
optional settings. Jumpers create shorts
between two pins to change the function
of the connector. Pin 1 is identifi ed with a
square solder pad on the printed circuit
board. See the motherboard layout pages
for jumper locations. Note: On two pin
jumpers, "Closed" means the jumper is
on and "Open" means the jumper is off
the pins.
GLAN Enable/Disable
JPL1 enables or disable GLAN 1 Port,
and JPL2 enables or disable GLAN 2 Port
on the motherboard. See the table on the
right for jumper settings. The default set-
ting is enabled.
GLAN 1/2 Enable
Jumper Settings
Jumper Setting Defi nition
Open Enabled
2-3 Disabled
A
B
A. GLAN1 Enable
B. GLAN2 Enable