Supermicro X7SBi - USB Wake-Up

2-24
X7SBi User's Manual
200
4
ITE
IDE CTRL
Battery
Super I/O
Slot1 PCI 33 MHz
Slot6 SXB2 PCI-X 133 MHz
Slot6 SXB1 PCI-Exp. x8
JBT1
JPG1
ATI
ES1000
VGA
CTRL
JPL1
Intel
LAN
CTRL
Buzzer
Intel
LAN
CTRL
BIOS
KB/MS
USB0/1
COM1
VGA
LAN1
LAN2
Fan6
ATX 24-Pin PWR
CPU Fan
SMB PS
Fan1
8-Pin PWR
CPU
MCH
Intel 3210
Xeon
3000/3200
DIMM1A
DIMM1B
DIMM2A
DIMM2B
Fan 5
JLED1
LE1
JOH
Fan2
Fan3
JL1
JWD
Speaker
IDE
Floppy
Fan4
SATA0
SATA1
SATA2
SATA3
SATA4
SATA5
JWOL
JI
2
C1
JI
2
C2
COM2
Printer
SIMSO (IPMI 2.0)
JPL2
Intel ICH9R
PXH-V
USB8/9 USB6/7
FP USB10
FP USB11
FP CTRL
JUSB1
JWOR
JPUSB2
T-SGPIO2
T-SGPIO1
X7SBi
USB Wake-Up
These jumpers allow you to wake up the system by
pressing a key on the USB keyboard or by click-
ing the USB mouse of your system. The JPUSB
jumpers are used together with the USB Wake-Up
feature in the BIOS. Enable both the jumpers and
the BIOS setting to use this feature. See the table
on the right for jumper settings and jumper con-
nections. Note: JPUSB1 is for Back Panel USB
ports:0/1, and JPUSB2 is for Front Panel USB
connections: 6/7/8/9/10/11.
Note: JPUSB1 should be enabled by default to
allow BP USB0 and BP USB1 to wake up from
the Standby Mode. However, the default jumper
setting for the JPUSB2 is Disabled. When the
USB Wake-Up feature is enabled in the BIOS, and
the USB ports are also enabled via the JPUSB
jumpers, please be sure to remove all other USB
devices from the USB ports whose USB jumpers
are set to Disabled before the system goes into
the standby mode.
A
A. JPUSB1
B. JPUSB2
B
USB Wake-Up
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled