Supermicro X7SBi - Page 94

C-6
X7SBi User's Manual
Creating a RAID 10 (RAID 1+ RAID 0):
a. DDR2 "Create RAID Volume" from the main menu and press the <Enter> key.
The following screen will appear:
b. Specify a name for the RAID 10 set and press <Enter>.
c. When RAID Level item is highlighted, use the <Up Arrow>, <Down Arrow> keys
to DDR2 RAID 10 (RAID1 + RAID0) and hit <Enter>.
d. When the Stripe Size is highlighted, use the <Up Arrow>, <Down Arrow> keys
to DDR2 the stripe size from 4 KB to 128 KB for your RAID 10 and hit <Enter>.
The default setting is 6 4KB. (Note: For a server, please use a lower stripe size,
and for a multimedia system, use a higher stripe size.)
e. When the RAID Volume Capacity item is highlighted, enter your RAID volume
capacity and hit <Enter>. The default setting is the maximum capacity allowed.
f. Press <Enter> when the Create Volume item is highlighted. A warning message
displays.
f. When asked "Are you sure you want to create this volume (Y/N), press "Y" to
create the RAID volume, or type "N" to go back to the Create Volume menu.