Supermicro X9DRD-iF User Manual

Chapter 1: Overview
1-9
• Power-on mode for AC power recovery
• Intel® Intelligent Power Node Manager (NM) (Available
when the NMView utility is installed in the system)
• Management Engine (ME)
PC Health
CPU Monitoring
Monitoring
• Onboard voltage monitors for 1.8V, +3.3V, 3.3VSB, +5V,
+5V SB, +12V, Chipset Voltage, and Battery Voltage.
• CPU 5-Phase switching voltage regulator
• CPU/System overheat LED and control
• CPU Thermal Trip support
• Thermal Monitor 2 (TM2) support
Fan Control
• Fan status monitoring with rmware 4-pin (Pulse Width
Modulation) fan speed control
• Low noise fan speed control
System
Manage-
ment
• PECI (Platform Environment Conguration Interface)
2.0 support
• UID (Unit Identication)/Remote UID
• System resource alert via SuperDoctor® III
• SuperDoctor® III, Watch Dog, NMI
• Chassis Intrusion Header and Detection
Dimen-
sions
• 13.00" (L) x 10.30" (W) (330.20 mm x 261.62 mm)
Note 1: For IPMI Conguration Instructions, please refer to the Embedded
IPMI Conguration User's Guide available @ http://www.supermicro.com/
support/manuals/.
Note 2: Changing BMC log-in information is recommended during initial
system power-on. The default username is ADMIN and password is
ADMIN. For BMC best practices, please refer to: http://www.supermicro.
com/products/nfo/les/IPMI/Best_Practices_BMC_Security.pdf

Supermicro X9DRD-iF Specifications

General

Brand	Supermicro
Model	X9DRD-iF
Category	Motherboard
Language	English