2-1
Chapter 2: System Safety
Chapter 2
System Safety
2-1 Overview
This chapter provides a quick setup checklist to get your chassis up and running.
Following the steps in order given should enable you to have your chassis set up
and operational within a minimal amount of time. This quick setup assumes that you
are an experienced technician, famailiar with common concepts and terminology.
2-2 Warnings and Precautions
You should inspect the box the chassis was shipped in and note if it was damaged
in any way. If the chassis itself shows damage, le a damage claim with carrier
who delivered your system.
Decide on a suitable location for the rack unit that will hold that chassis. It should
be situated in a clean, dust-free area that is well venilated. Avoid areas where heat,
electrical noise and eletromagnetic elds are generated.
You will also need the system placed near at least one grounded power outlet. When
congured, the SC847 chassis includes one power supply. "R" models include a
redundant power supply and require two grounded outlets.
2-3 Preparing for Setup
The SC847 chassis includes a set of rail assemblies which includes mounting brack-
ets and mounting screws you will need to install the systems into the rack. Please
read this manual in its entirety before you begin the installation procedure.
To Next Page
Loading...
Need help?
General
