11
EN
i
Exceeding the maximum permissible running time
(KB) may overload and damage the roller shutter
belöt winder.
◆ The maximum permissible running time for a cycle
may not be exceeded when the equipment is in
operation. For this reason, the roller shutter belt
winder has an automatic running time limit (KB)
of four minutes.
◆ If the running time limit is triggered, then the
roller shutter belt winder must be left for at least
30 minutes to cool down. Full operational availability
is re-established after approx. one hour
According to DIN EN 13659, it is necessary to determine
that the movement conditions for the shutters are
maintained in accordance with EN 12045.
◆ The displacement must be of at least 40 mm on the
lower edge in the rolled-out position with a force of
150 N in the upwards direction.
◆ In doing so, it must be ensured that the extending
speed of the shutters for the nal 0.4 m is less than
0.15 m/s.
6. Safety instructions
i
6.1 Intended use
Only use the roller shutter belt winder for opening and
closing roller shutters with a permissible belt.
i
Mechanical locks of any kind are not suitable
for automated operation with this device.
To Next Page
Loading...