CM2020 Amplifier - Installation Manual
20
Copyright 2011 Cellphone-Mate, Inc. All rights reserved.
2. Attach the included mounting kit to the ampli-
fier using the screws provided. Tighten the
screws by hand with a screwdriver until snug
plus 1/4 to 1/2 turn. Do not over-tighten.
3. Mount the amplifier to the wall using appro-
priate screws and/or wall anchors. The top
side of the amplifier with the lights and DIP
switches should be facing away from the wall
and be plainly visible when standing near the
amplifier.
4. Connect the exterior antenna cable to the
Outside Antenna port on the amplifier.
5. Connect the interior antenna cable to the
Inside Antenna port on the amplifier.
6. Verify that all cable connections are snug and
that the exterior and interior antennas are
connected to the proper jacks.
CAUTION: DO NOT POWER ON THE
AMPLIFIER UNTIL INSTRUCTED TO DO
SO.
CAUTION: NEVER POWER ON THE
AMPLIFIER WHEN ANY ANTENNAS ARE
DISCONNECTED AS THIS COULD DAM-
AGE THE AMPLIFIER.
To Next Page
Loading...