SureCall CM2020 - Industry Canada

To Next Page

To Previous Page

CM2020 Ampliﬁer - Installaon Manual

• Connect the equipment to an outlet on a cir-

cuit diﬀerent from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV

technician for help.

This equipment complies with FCC radiaon expo-

sure limits set forth for an uncontrolled environ-

ment. This transmier must not be co-located or

operang in conjuncon with any other antenna

or transmier. In accordance with FCC require-

ments of human exposure to radio frequency

ﬁelds, the radiang element (antenna) shall be

installed such that a minimum separaon distance

of 25cm (11in) is maintained from all persons.

7.2 - Industry Canada

IC ID: 7784A-D85UNDER

This device meets all requirements of the Cana-

dian Interference Causing Equipment Regulaons.

Operaon is subject to the following two condi-

ons: (1) this device may not cause harmful inter-

ference, and (2) this device must accept any

interference received, including interference that

may cause undesired operaon.

The term “IC:” before the radio cerﬁcaon num-

ber only signiﬁes that Industry Canada technical

speciﬁcaons were met.

RF Exposure: The manufacturer’s rated output

power of this equipment is for single carrier oper-

aon. For situaons when mulple carrier signals

are present, the rang would have to be reduced

by 3.5 dB, especially where the output is re-radi-