SureCall CM2020 - Initial Configuration; Powering on the Amplifier

CHAPTER 5: Configuraon & Tesng
Copyright 2011 Cellphone-Mate, Inc. All rights reserved.
23
• Turning ON all switches in a bank =
1+2+4+8+16dB aenuaon = 31dB aenua-
on. For example, in a 68dB amplifier, that
means that the selected channel would be
reduced to 37dB (68dB-31dB).
5.2 - Inial Configuraon
By default, your amplifier ships with all DIP
switches turned OFF to provide maximum gain in
all channels. This should always be your starng
point whenever installing or reinstalling the
amplifier.
5.3 - Powering on the Amplifier
To power on the amplifier:
1. Make sure that exterior and interior antenna
cables are snugly connected to the proper
ports on the amplifier.
2. Plug a surge suppressor into a grounded
110VAC wall outlet.
3. Plug the AC end of the power adapter that
came with the amplifier into the surge sup-
pressor.
4. Plug the DC end of the power adapter into the
Power port on the amplifier.
CAUTION: ONLY USE THE POWER SUP-
PLY INCLUDED WITH THE AMPLIFIER.
USE OF ANOTHER POWER SUPPLY
COULD DAMAGE THE AMPLIFIER AND/
OR POWER SUPPLY.