SureCall Fusion2Go 2.0 - Troubleshooting

SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | Support@surecall.com
8
SpecicationsTroubleshooting
Troubleshooting
Problem Resolution
Signal booster has no
power
Verify that the LED on the booster is ON.
Connect the power supply to an alternate power source.
Verify that the power source is operational and the fuse is intact.
If the POWER LED on the signal booster is OFF, return the power supply to SureCall. Contact tech support at to
receive an RMA at:
1-888-365-6283 or support@surecall.com.
After completing
installation, signal has
not Improved
Verify that cable connections are tightly tted to the booster.
Try further separating the antennas.
 Remember: Bars are not always a reliable measure of signal. The best way to conrm signal coverage is the
ability to place and hold a call.