SureCall Fusion2Go 2.0 - Specifications

SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | Support@surecall.com
9
Specications
RF Exposure Warning:
The inside patch antenna must be installed so as to provide a separation distance of al least 20 cm (8 inches) from all persons
The Manufacturer’s rated output power of this equipment is for single carrier operation. For situations when multiple carrier signals are present,
the rating would have to be reduced by 3.5 dB, especially where the output signal is re-radiated and can cause interference to adjacent band
users. This power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device.
Specications
Product Fusion2Go 2.0 US Fusion2Go 2.0 Canada
Uplink Frequency Range (MHz): 698-716 / 776-787 / 824-849 / 1850-1915 / 1710-1755 (G Block Included)
Downlink Frequency Range (MHz): 728-746 / 746-757 / 869-894 / 1930-1995 / 2110-2155 (G Block Included)
Input / Output Impedance: 50 Ω
Maximum Gain: 50 dB 47.8 dB
Noise Figure: ≤ 5 dB
VWSR: ≤ 2.0
Gain Adjustment: 20 dB (Automatic)
Supported Standards: CDMA, WCDMA, GSM, EDGE, HSPA+, EVDO, LTE and all cellular standards
DC Power: 6-15V
Maximum Output Power: 1 Watt EIRP 3 Watt EIRP
Cable: SC-174
RF Connectors: FME Male (both ends)
Power Consumption: ≤ 10W
Operation Temperature: -4º to +158º F
Dimensions: 5.625 x 4 x 1.125 inches
Weight: 1.43 lbs
FCC / IC ID: RSN2GOMINI 7784A-2GOMINI