SureCall Fusion2Go 3.0 - LED Indicators; Troubleshooting

SureCall | www.surecall.com | 1-888-365-6283 | support@surecall.com
8
SpecicationsTroubleshooting
LED Indicators
In the event Red LEDs appear either solid or ashing, further separation between the booster and
outside antenna is recommended.
Note that the booster case may become warm during operation. This is normal.
Troubleshooting
Problem Resolution
Signal booster has no
power
Verify that the Power LED is ON.
Connect the power supply to an alternate power source.
Verify that the power source is operational and the fuse is intact.
If it remains OFF, contact tech support at:
1-888-365-6283 or support@surecall.com
After completing
installation, signal has
not Improved
Verify that cable connections are tightly tted to the booster.
Try further separating the antennas.
 Note: Bars are not always a reliable measure of signal. The best way to conrm signal coverage is the ability to
place and hold a call.