39
router to configure this router. To access the setting page from external side, enter “http://<WAN IP
Address>:8080” into the web browser address column.
Note: For Security consideration, it is recommended not to enable this function if not necessary. When
Remote management is enabled, please change your Webserver Port 80.
3.8 Status Monitor
This page displays the information of this router. Click “Reload” to re-fresh the current information
3.9 RIP
RIP stands for Routing Information Protocol. RIP sends routing-update messages at regular
intervals and when the network topology changes. It uses a single routing metric (hop count) to
measure the distance between the source and a destination network. RIP maintain only the best
route (the route with the lowest metric value) to a destination. After updating its routing table,
the router immediately begins routing updates.
This router provides two kinds of routing mode to choose, Dynamic Routing and Static Routing.
Dynamic Routing means that it can be used to cache routes learned by RIP, thus allowing the
automation of static routing maintenance. Static Routing only receives routing tables from other
routers and does not send its own routing table to others. You can refer to the Static Routing page
To Next Page
Loading...
Need help?
General
