SureShade Power Bimini - Page 18

18
lci1.com Rev: 03.10.20574-537-8900 CCD-0003622
INSTALLATION
SECURING STRAPS
STEP 1  SELFTAPPING MALE SNAPS
TOOLS REQUIRED:
1. Pencil
PARTS REQUIRED:
A. SureShade Power Bimini
B. Bimini top (canvas)
NOTE: The male snaps with self-tapping screws are provided by the bimini top (canvas) manufacturer. If male
snaps did not come with the canvas, contact the canvas manufacturer.
Install the canvas top onto the power bimini top. The canvas top has securing straps with female snaps located at
the bow port and starboard corners and aft port and starboard corners. Securing straps prevent undo billowing
of the top when installing the boot.
Starting at one canvas corner, tightly pull and wrap the securing strap around the bimini top strut. Mark the
location of the female snap on the strut. Repeat procedure for each securing strap.
Securing Strap
Strut
Canvas Top
Female Snap