SureShade Power Bimini - Page 19

19
Rev: 03.10.20 lci1.com574-537-8900 CCD-0003622
INSTALLATION
Installed
Male Snap
Male Snap with
Self-tapping Screw
Strut
SECURING STRAPS
STEP 2  SELFTAPPING MALE SNAPS
TOOLS REQUIRED:
1. Cordless or electric drill or screw gun
2. Appropriate drive bit
PARTS REQUIRED:
A. Male snaps with self-tapping screws
B. SureShade Power Bimini
C. Bimini top (canvas)
NOTE: The male snaps with self-tapping screws are provided by the bimini top (canvas) manufacturer. If male
snaps did not come with the canvas, contact the canvas manufacturer.
Locate the previously marked location for the male snap. Position the self-tapping screw of the male snap over
the mark and use a drill or screw gun to install the male snap into the strut.
Wrap the securing strap around the strut as before then snap the strap in-place. Repeat procedure for each
securing strap.