Need help?Do you have a question about the SureShade Power Bimini and is the answer not in the manual?
Slide the rear strut assembly over actuator rear receiver handle. Secure using 1/4" hex cap screws.
Locate the rear strut/actuator assembly so that when the top is down, the struts are just behind the rear seats.
Measure back 1/2" and 16-1/2" from pencil line and drill 3/8" holes in the frame.
Run the wire from the actuator to the helm, choosing a path inside or along the boat's rear frame.
Perform manual override if the power bimini top will not close. Relieve pressure, remove screws, and lift frame off gear handles.
General| Material | Marine-Grade Materials |
|---|---|
| Power Source | 12V DC |
| Frame Material | Anodized Aluminum |
| UV Protection | Yes |
| Installation | Professional Installation Recommended |
| Category | Boat |
| Control | Remote Control |
| Size Options | Multiple sizes available |
| Operation | Electric |
| Coverage Area | Varies by Size |
| Fabric Material | Marine-Grade Fabric |
| Water Resistance | Water-resistant fabric |
| Compatibility | Varies by boat model; consult manufacturer specifications |
To Next Page
