5
Rev: 03.10.20 lci1.com574-537-8900 CCD-0003622
INSTALLATION
STEP 4 RUN WIRE
At this time you will need to run the wire from the actuator to the helm. Each boat is dierent, so the best way will be
determined by you. Here are a few options to help you decide.
1) Inside the boat’s rear frame
2) Along the bottom side of the boat’s rear frame
3) Along the top or side of the boat’s rear frame
Options 1 and 2
Drill a third hole in the top of the boat’s rear frame to accept the actuator wire. For option 1 this new hole will be drilled
half way through the frame, with option 2 this hole will be drilled all of the way through the boat’s frame. Locate this
new hole by looking at where the wire exits the actuator and then transfer this location to the boat’s rear frame and
drill the hole. For option 1, snake the wire through the inside of the rear frame until it exits under the boat. From this
point, run the wire to the underside of the helm and sh it up into the helm. For option 2, run the wire under the top
frame using fastener-mount zip ties (not included) to support the wire, direct entry to the helm from the top frame is
normally possible.
Option 3
Bolt down the actuator as shown in Step 5. Use fastener-mount zip ties (not included) to run the wire along the top or
side of the boat frame and into the helm.
To Next Page
Loading...
