GSF1200AK6/SAK6 (’06-MODEL) 29
Step 4
1) Turn the ignition switch to OFF.
2) Disconnect the ABS control unit coupler. (!Page 26)
3) Turn the ignition switch to ON with the ABS control unit cou-
pler disconnected, measure the voltage between
F (O/Y)
and
N (B/W) at the coupler.
% Normal value: Battery voltage (12.0 V and more)
" 09900-25008: Multi-circuit tester set
& Tester knob indication: Voltage (')
Is the voltage between
F and
N normal?
Step 5
1) Turn the ignition switch to ON with the ABS control unit cou-
pler disconnected, measure the voltage between
A (Brown)
and
N (B/W) at the coupler.
% Normal value: Battery voltage (12.0 V and more)
& Tester knob indication: Voltage (')
Is the voltage between
A and
N normal?
Step 6
1) Turn the ignition switch to OFF.
2) Check for continuity between
N (B/W) at the coupler and
body ground, also
O (B/W) at the coupler and body ground.
( Tester knob indication: Continuity ())
Are there continuity between
N (
O) and body ground?
YES Go to step 5.
NO
Inspect the wire harness. (Faulty ignition or
ground wire)
ABS control unit coupler (Harness end)
YES Go to step 6.
NO
Inspect the wire harness. (Faulty indicator light
wire)
Signal fuse or indicator light is blown.
(!Page 75)
ABS control unit coupler (Harness end)
YES Replace the ABS control unit/HU.
NO Inspect the wire harness. (Faulty ground wire)
ABS control unit coupler (Harness end)
SAMPLE
To Next Page
Loading...
