8
HANDLEBARS
Loosen the right switch retaining screws and throttle
housing retaining bolts.
Insert the right switch and throttle assembly onto the
handlebars.
A: Throttle assembly
B: Right switch
C: Handlebars
Install the handlebars assembly with the two clamps,
four bolts and washers.
A: Clamp
B: 8 × 30 mm flange bolt
C: Burring washer OD:13.0 mm ID:8.5 mm
D: Punch mark
E: Dot mark
Tighten the handlebar clamp bolts to the specified
torque.
Handlebar clamp bolt: 23 N·m (2.3 kgf-m)
A: 8 × 30 mm flange bolt
B: 8 × 30 mm flange bolt
NOTE:
• Install the burring washer in the direction as
shown in the illustration.
• Install each clamp with the punch mark facing
front.
• Align the dot mark on the handlebars with the
mating surface of the front side of left clamp.
NOTE:
• First tighten the bolt A of the front side with
specified torque and then tighten the bolt B of
the rear side.
• Make sure that the clamp has no clearance at the
front side.
FRONT
To Next Page
Loading...
