11
LEFT SWITCH
Insert the boss of left switch housing into the hole on
the handlebars.
Install the left switch assembly with two screws.
A: Boss
B: Hole
C: 5 × 25 mm screw
CLUTCH MASTER CYLINDER
Install the clutch master cylinder onto the handlebars.
A: Holder
B: Clutch master cylinder
C: 6 × 22 mm flange bolt
D: 6 × 22 mm flange bolt
E: Dot mark
Tighten the clutch master cylinder mounting bolts to
the specified torque.
Clutch master cylinder mounting bolt:
10 N·m (1.0 kgf-m)
A: 6 × 22 mm flange bolt
B: 6 × 22 mm flange bolt
C: Holder
D: Clutch master cylinder
E: Handlebars
NOTICE
Pinching the lead wires in the parts can short or
break circuit.
Check the lead wire routing when assembling
the switch.
NOTE:
• Install the holder in position according to the
mark “UP”.
• Align the dot mark on the handlebars with the
master cylinder-to-holder fitting surface.
NOTE:
• First tighten the bolt A of the upper side with
specified torque and then tighten the bolt B of
the lower side.
• Make sure that the holder has no clearance at
the upper side.
To Next Page
Loading...
