6-33
(GSX-S1000F/FA)
Remove the meter panel and fairings
by referring to the METER PANEL
REMOVAL AND INSTALLATION,
FAIRING REMOVAL AND INSTALLA-
TION section.
Remove the filler cap and add speci-
fied engine coolant through the filler
hole until it reaches the “F” line. Refer
to the FUEL, ENGINE OIL AND
COOLANT RECOMMENDATIONS
section.
NOTE: When installing the filler cap,
face the triangle mark to the reservoir
tank hose side.
NOTE: Adding only water will dilute
the engine coolant and reduce its
effectiveness. Add specified engine
coolant.
CHANGING THE COOLANT
Change the coolant periodically.
NOTE: About 2800 ml (6.0/5.0 US/
Imp. qt) of coolant will required when
filling the radiator and reservoir tank.
RADIATOR HOSE INSPECTION
Inspect the radiator hoses for cracks,
damage or engine coolant leakage. If
any defects are found, ask your
Suzuki dealer to replace the radiator
hose with a new one.
WARNING
Engine coolant is harmful or fatal
if swallowed or inhaled. Solution
can be poisonous to animals.
Do not drink antifreeze or coolant
solution. If swallowed, do not
induce vomiting. Immediately con-
tact a poison control center or a
physician. Avoid inhaling mist or
hot vapors; if inhaled, remove to
fresh air. If coolant gets in eyes,
flush eyes with water and seek
medical attention. Wash thor-
oughly after handling. Keep out of
the reach of children and animals.
To Next Page
Loading...
