6-10
6. Tighten the fastener 1 and bolt 2
on the front end of the meter
panel, and tighten the bolt 3 on
the rear end of the meter panel in
the numbered order.
NOTE: When tightening the bolt 3 on
the rear end of the meter panel, the
mating condition around the meter
panel can be improved by performing
the work while pushing the bottom of
the meter panel and the end face of
the fairing (place marked with a circle)
in the direction of the arrow so that
they are aligned.
FAIRING REMOVAL AND
INSTALLATION (GSX-S1000F/FA)
REMOVAL
1. Place the motorcycle on the side
stand.
2. Remove the right and left fairing
bolts and inner fairing fasteners.
To Next Page
Loading...
