2-29
NOTE:
• Be sure to keep the throttle fully
closed when changing the mode.
If the change of mode is not possi-
ble because the throttle is not fully
closed, a segment of the selected
mode on the traction control sys-
tem display blinks.
• The setting is retained in the
memory even when the ignition
switch is turned off.
• The setting of the traction control
system is retained in the memory
even when the battery becomes
fully discharged or is discon-
nected and removed from the
motorcycle.
RIGHT HANDLEBAR
(EU)
ENGINE STOP SWITCH 1
“” position
The ignition circuit is off. The engine
cannot start or run.
“” position
The ignition circuit is on and the
engine can run.
FRONT BRAKE LEVER 2
The front brake is applied by squeez-
ing the brake lever gently toward the
throttle grip. This motorcycle is
equipped with a disk brake system
and excessive pressure is not
required to slow the machine down
properly. The brake light will be lit
when the lever is squeezed inward.
To Next Page
Loading...
