6-57
Low beam
High beam
(GSX-S1000F/FA)
To adjust the beam up and down:
Turn the adjuster 1 clockwise or
counterclockwise.
To adjust the beam right and left:
Turn the adjuster 2 clockwise or
counterclockwise.
TURN SIGNAL LIGHT
To replace the turn signal light bulb,
follow these directions.
1. Remove the screw and take off
the lens.
2. Push in on the bulb, twisting it to
the left, and pull it out.
3. To fit the replacement bulb, push it
in and twist it to the right while
pushing.
NOTICE
Overtightening the screws when
reinstalling the lens may cause
the lens to crack.
Tighten the screws only until they
are snug.
To Next Page
Loading...
