2-31
ELECTRIC STARTER SWITCH “”
3
This switch is used for operating the
starter motor. With the ignition switch
in the “ON” position, the engine stop
switch in “” and the transmission in
neutral, push the electric starter
switch to start the engine.
NOTE: When the electric starter
switch is pushed, the starter motor
will continue turning for about 1.5 sec-
onds even when you release your
hand from the switch. After elapsing
about 1.5 second, or when the engine
is started, the starter motor will stop
automatically.
NOTE: This motorcycle is equipped
with an interlock system for the igni-
tion circuit and the starter circuit. The
engine can only be started if:
• The transmission is in neutral, or
• The transmission is in gear, the
side stand is fully up and the
clutch is disengaged.
NOTE: The headlight will go off when
the electric starter switch is pushed.
THROTTLE GRIP 4
Engine speed is controlled by the
position of the throttle grip. Twist it
toward you to increase engine speed.
Turn it away from you to decrease
engine speed.
HAZARD WARNING SWITCH “”
5 (EU)
All four turn signal lights and indica-
tors will flash simultaneously when
the switch is turned on with the igni-
tion switch in the “ON” or “P” position.
Use the hazard warning lights to warn
other traffic during emergency park-
ing or when your vehicle could other-
wise become a traffic hazard.
NOTICE
Engaging the starter motor for
more than five seconds at a time
can damage the starter motor and
wiring harness from overheating.
Do not engage the starter motor
for more than five seconds at a
time. If the engine does not start
after several attempts, check the
fuel supply and ignition system.
Refer to the TROUBLESHOOTING
section in this manual.
To Next Page
Loading...
