6-25
ENGINE OIL AND FILTER CHANGE
Change the engine oil and oil filter at
the scheduled time. The oil should be
changed when the engine is warm so
that the oil will drain thoroughly from
the engine. The procedure is as fol-
lows:
1. Place the motorcycle on the side
stand.
(GSX-S1000/A)
2. Remove the right and left bolts.
Remove the under cowlings 1.
(GSX-S1000F/FA)
Remove the meter panel and fair-
ings by referring to the METER
PANEL REMOVAL AND INSTAL-
LATION, FAIRING REMOVAL
AND INSTALLATION section.
NOTICE
Operating the motorcycle with too
little or too much oil can damage
the engine.
Place the motorcycle on level
ground. Check the oil level with
the engine oil inspection window
before each use of the vehicle. Be
sure the engine oil level is always
above the “L” (low) line and not
higher than the “F” (full) line.
To Next Page
Loading...
