6-35
To adjust the cable play:
1. Loosen the lock nut 1.
2. Turn the adjuster 2 so that the throttle
grip has 2.0 – 4.0 mm (0.08 – 0.16 in)
play.
3. Tighten the lock nut 1.
CLUTCH
The clutch release mechanism of this motor-
cycle is operated by hydraulic pressure.
There is no adjustment needed on the clutch
release system because the system is self
adjusting. However, inspect the following
each time before driving to make sure that
the system is in good condition and function-
ing properly.
WARNING
Inadequate throttle cable play can cause
engine speed to rise suddenly when you
turn the handlebar. This can lead to loss
of rider control.
Adjust the throttle cable play so that
engine idle speed does not rise due to
handlebar movement.
LOWER
To Next Page
Loading...
