6-66
LIGHT BULB REPLACEMENT
The wattage rating of each bulb is shown on
the table below. When replacing a burned
out bulb, always use the exact same wattage
rating. Using other than the specified rating
can result in overloading the electrical sys-
tem or premature failure of a bulb.
HEADLIGHT
To replace the headlight bulb, perform the
following steps:
1. Remove the bolts 1. Tilt up the rear end
of the instrument panel.
CAUTION
Using a light bulb with the wrong watt-
age rating can cause electrical system
damage or shorten bulb life.
Always use the specified light bulb.
Headlight 12V 60/55W (H4)
Position light 12V 5W × 2
Turn signal light 12V 21W × 2
License plate light 12V 5W
To Next Page
Loading...
