2-58
To set the compression damping force
adjuster to the standard position, turn the
adjuster clockwise until it stops and then
turn it counterclockwise 2 turns until the two
punch marks align. If the two punch marks
do not align by turning out 2 turns, turn in or
out the adjuster until two punch marks align.
Turn the adjuster clockwise from the stan-
dard position to stiffen the damping force.
Turn the adjuster counterclockwise to soften
the damping force. The damping force
should be adjusted gradually, 1/8 turn at a
time, to fine-tune the suspension.
To Next Page
Loading...
