6-31
Check the engine oil level with the engine oil
dipstick. The dipstick comes out together
with the oil filler cap as shown. The level on
the dipstick should be between the “L” (Low)
and “F” (Full) lines.
The engine oil level inspection should be
performed under the following conditions:
1. Place the motorcycle on the side stand.
2. Start the engine and allow it to idle for
about three minutes. If the engine is
cold, warm up the engine sufficiently.
3. Stop the engine and wait approximately
three minutes.
4. Remove the oil dipstick and clean the
dipstick.
5. Hold the motorcycle vertically. Insert the
oil dipstick through the oil filler hole. The
oil filler cap threads should not be run in
but touching should be the filler hole
upper edge.
6. Pull out the oil dipstick and inspect the
oil level.
7. Refit the oil dipstick.
CAUTION
Exhaust pipes can be hot enough to
burn you.
Use gloves to avoid burns.
To Next Page
Loading...
