6-72
LIGHT BULB REPLACEMENT
The wattage rating of each bulb is shown on
the chart below. When replacing a burned
out bulb, always use the exact same wattage
rating. Using other than the specified rating
can result in overloading the electrical sys-
tem or premature failure of a bulb.
NOTICE
Failure to use a light bulb with the cor-
rect wattage rating can overload the
electrical system of your motorcycle or
cause the bulb to burn out sooner.
Use only the light bulbs shown in the
chart as replacement bulbs.
Headlight 12V 60/55W (H4)
Turn signal light
Front 12V 21W
Rear 12V 21W
Position light
(if equipped)
12V 5W
Licence plate light 12V 5W
To Next Page
Loading...
