8-2
STORAGE PROCEDURE AND
MOTORCYCLE CLEANING
STORAGE PROCEDURE
If your motorcycle is to be left unused for an
extended period of time, it needs special
servicing requiring appropriate materials,
equipment and skill. For this reason, Suzuki
recommends that you trust this maintenance
work to your authorized Suzuki dealer. If you
wish to service the machine for storage
yourself, follow the general guidelines
below:
MOTORCYCLE
Clean the entire motorcycle. Place the
motorcycle on the side stand on a firm, flat
surface where it will not fall over.
FUEL
1. Fill the fuel tank to the top with fuel
mixed with the amount of gasoline stabi-
lizer recommended by the stabilizer
manufacturer.
2. Run the engine for a few minutes until
the stabilized gasoline fills the fuel injec-
tion system.
ENGINE
1. Remove the spark plugs. Pour one table-
spoon of motor oil into each spark plug
holes. Reinstall the spark plugs and
crank the engine a few times.
2. Drain the engine oil thoroughly and refill
the crankcase with fresh engine oil all
the way up to the filler hole.
To Next Page
Loading...
