2-16
Damping Force Adjustment
The rebound and compression damp-
ing force can be individually adjusted
by turning the respective adjusters.
The rebound damping force adjuster
1 is located at the bottom of the rear
suspension. The compression damp-
ing force adjuster 2 is located at the
left side of the vehicle.
To adjust the damping force, set the
adjuster to the standard setting first
and then adjust the adjuster to the
desired position.
To set the rebound damping force
adjuster to the standard position, turn
the adjuster clockwise until it stops
and then turn it counterclockwise 1-1/2
turns.
To set the compression damping
force adjuster to the standard posi-
tion, turn the adjuster clockwise until it
stops and then turn it counterclock-
wise 2 turns.
Turn the adjuster clockwise from the
standard position to stiffen the damp-
ing force. Turn the adjuster counter-
clockwise to soften the damping
force. The damping force should be
adjusted gradually, 1/8 turn at a time,
to fine-tune the suspension.
To Next Page
Loading...
