9-3
WASHING YOUR ATV
With some care, your ATV can be
washed in a similar manner to wash-
ing an automobile.
NOTE: Avoid spraying or allowing
water to flow over the following
places:
• Ignition switch
• Spark plug
• Fuel tank cap
•Carburetor
• Brake master cylinder
• Snorkel air intake for air filter and
carburetor (The snorkel air intake
opening is located at the highest
point on the ATV, usually in front of
the seat.)
• Radiator fins
Use a garden hose at low pressure to
remove the majority of dirt or other
debris. Hand wash your ATV with mild
soap or detergent and water. Try to
thoroughly remove all dirt and debris
without excessive water pressure,
even at remote areas such as link-
ages or mounting brackets. Cloth
rags, washing mitts or cleaning
brushes can be used. Be careful with
brushes as they may scratch plastic
or painted surfaces. Rinse the ATV
thoroughly with clean water. Dry all
areas using a chamois or soft absor-
bent cloth.
CAUTION
Improper cleaning can damage the
oil cooler.
Oil cooler fins can be damaged by
spraying high pressure water on
them.
Do not spray high pressure water
on the oil cooler.
To Next Page
Loading...
