3-13
BRAKING
To stop the ATV, first release the throt-
tle lever. Next, apply the front and rear
brakes evenly and at the same time.
As vehicle speed decreases, shift
down through the gears.
PARKING
After stopping the ATV according to
the “BRAKING” section, shift to neu-
tral. Neutral position can be confirmed
by observing the neutral indicator
light. Park the ATV on a flat surface
and set the parking brake lock. Turn
the ignition switch to the “OFF” posi-
tion. Always remove the key from the
ATV when leaving the ATV.
WARNING
Braking while turning the ATV can
be hazardous.
Use of the brake when turning
could cause the ATV to slide or
roll over.
Use the brakes to slow down
before you begin to turn.
WARNING
Braking hard on slippery surfaces
can be hazardous.
The ATV can skid and go out of
control if you brake too hard.
Apply the brakes lightly and with
care on slippery surfaces.
WARNING
Operating the parking brake lock
when the ATV is moving can be
hazardous.
The rear wheels can lock, causing
a skid and an accident.
Use the parking brake only after
you stop the ATV.
To Next Page
Loading...
