5-9
4. Stop the engine and wait three
minutes.
5. Remove the oil filler cap 2. The
engine oil dipstick comes out
together with the oil filler cap.
6. Wipe the oil from the dipstick
using a clean rag.
7. Reinsert the dipstick until the
threads touch filler neck, but do
not screw the cap in.
NOTE: Engine oil expands and oil
level increases when the engine oil is
hot. Check and adjust engine oil level
when the engine oil is not hot.
8. Draw out the dipstick and check
the oil level. The level found on the
dipstick should be between “L”
(Low) and “F” (Full) lines. If the oil
level is below the “L” line, add
fresh oil into the filler hole until the
oil level reaches the “F” line.
LF
CAUTION
Operating the vehicle with an
incorrect amount of oil can dam-
age your ATV.
Too little or too much oil can dam-
age your engine.
Place the ATV on level ground.
Check the oil level with the engine
oil dipstick before each use of the
vehicle. Be sure the engine oil
level is always above the “L” (low)
line and not higher than the “F”
(full) line.
To Next Page
Loading...
