8 SV1000K3
• Install the left handlebar switch to the handlebars by engaging
the stopper
5 with the handlebar hole
6.
• Install the clutch master cylinder. (#SV1000S 6-94 and
below)
• Install the handlebar balancers and rear view mirrors.
(Handlebar balancer installation: #16)
MASTER CYLINDER REMOUNTING
FRONT BRAKE
• When remounting the brake master cylinder onto the handle-
bars, align the master cylinder holder’s mating surface
A with
punch mark
B on the handlebars and tighten the upper clamp
bolt first as shown.
" Front brake master cylinder mounting bolt:
10 N·m (1.0 kgf-m, 7.0 lb-ft)
CLUTCH
• When remounting the clutch master cylinder on the handle-
bars, align the master cylinder holder’s mating surface
A with
punched mark
B on the handlebars and tighten the upper
clamp bolt first.
" Clutch master cylinder mounting bolt:
10 N·m (1.0 kgf-m, 7.0 lb-ft)
“UP” mark
Master
cylinder
Master
cylinder
holder
Handlebars
“UP” mark
Master
cylinder
Handlebars
Master
cylinder
holder
To Next Page
Loading...
