7-45
TURN SIGNAL LIGHT
To replace the turn signal light
bulb, follow these directions.
1. Remove the screw and take off
the lens.
2. Push in on the bulb, turn it to
the left, and pull it out.
3. To fit the replacement bulb,
push it in and twist it to the
right while pushing.
LICENSE PLATE LIGHT
To replace the license plate light
bulb, follow the procedure steps:
1. Remove the screws 1 and
take off the cover with the lens.
2. Pull off the bulb from the
socket.
3. To replace the license plate
light, reverse the above steps.
NOTICE
Overtightening the screws
when reinstalling the lens may
cause the lens to crack.
Tighten the lens screws only
until they are snug.
To Next Page
Loading...
