3-11
When the display indicates
“CHEC” in the odometer display
area, check the following items;
• Make sure that the engine stop
switch is in the “
” position.
• Make sure that the transmis-
sion is in neutral or the side
stand is fully up.
If the display still indicates
“CHEC” after checking the above
items, inspect the ignition fuse
and the connection of the lead
wire couplers.
High Beam Indicator Light “
”
9
This blue indicator light will be lit
when the headlight high beam is
turned on.
Clock 0
Time is shown when the ignition
switch is in the “ON” position. The
clock has a 12-hour display. Fol-
low the procedure below to adjust
the clock.
To adjust the clock, press and
hold the SEL button 1 and the
ADJ button 2 simultaneously for
2 seconds until the clock display
blinks.
1. Push the SEL button 1 to
adjust the hour display.
2. Push the ADJ button 2 to
adjust the minute display.
3. Press and hold the SEL button
1 and the ADJ button 2
simultaneously for 2 seconds
to return to the clock mode.
NOTE:
• When the SEL button 1 or the
ADJ button 2 is pressed and
held, the display will increase
continuously.
• The clock can be adjusted
when the ignition switch is in
the “ON” position.
• This clock is powered by the
battery of the motorcycle. If
your motorcycle is to be left
unused more than two months,
remove the battery from the
motorcycle.
To Next Page
Loading...
