3-12
Odometer/Trip Meter/
Instrument Panel Light
Brightness A
The display has 4 functions;
odometer, two trip meters, and
instrument panel light brightness.
When the ignition switch is turned
to the “ON” position, the test pat-
tern shown below is displayed for
3 seconds. After the test pattern is
displayed, the display will show
the function that was displayed
the last time that the ignition
switch was turned off.
NOTE:
• Set the meter A to odometer,
then press and hold the SEL
button 1 for 2 seconds to
switch between mile and km.
At this time, the speedometer
will be changed between mph
and km/h and the instanta-
neous/average fuel consump-
tion meter will be changed
between MPG and km/L (L/
100 km).
• Select mile or km, as appropri-
ate, to comply with traffic regu-
lations.
• Check the mile and km display
after adjusting the instrument
panel display.
TRIP
A B
TRIP
To Next Page
Loading...
