7-21
8. Mark the top dead center posi-
tion on the “cap type” filter
wrench or on the oil filter. Use
an oil filter wrench to tighten
the filter 2 turns or to specified
torque.
Oil filter tightening torque:
20 N·m (2.0 kgf-m, 14.5 lbf-ft)
9. Replace the drain plug gasket
3 with a new one. Reinstall the
drain plug 2 and gasket 3.
Tighten the drain plug securely
with a torque wrench. Pour
about 2750 ml (2.9 US qt) of the
specified engine oil in the filler
hole. (See FUEL, ENGINE OIL
AND COOLANT RECOMMEN-
DATIONS section.)
Drain plug tightening torque:
21 N·m (2.1 kgf-m, 15.0 lbf-ft)
NOTE: About 2400 ml (2.5 US qt)
of oil will be required when chang-
ing oil only.
10.Start the engine (while the
motorcycle is outside on level
ground) and allow it to idle for
three minutes.
11.Turn the engine off and wait
approximately three minutes.
Recheck the oil level on the
engine oil inspection window
while holding the motorcycle
vertically. If it is lower than the
“L” line, add oil until the oil level
is between the “L” line and the
“F” line. Inspect the area
around the drain plug and oil
filter for leaks.
NOTE: If you do not have a proper
oil filter wrench, have your Suzuki
dealer perform this service.
Mark top dead center
Oil filter wrench
Tighten the filter 2 turns or
to specified torque.
In the position at which
the filter gasket first
contacts the mounting
surface.
NOTICE
Engine damage may occur if
you use oil that does not meet
Suzuki’s specifications.
Be sure to use the oil specified
in the FUEL, ENGINE OIL AND
COOLANT RECOMMENDA-
TIONS section.
To Next Page
Loading...
