Sven HT-210 - Bluetooth and Standby Mode; Audio Settings Reset and Maintenance Notes

ENG
10
5.1 Active Home Theater
Speaker System With Bluetooth
Bluetooth mode
• In order to transmit signal in this mode it is necessary at first to connect the device with a signal
source (see Fig. 5). For this purpose select the Bluetooth mode using the volume control knob
INPUT h on the front panel or button INPUT a on the RC. After 2-3 seconds the speaker system
will enter the search mode, “BLU” mode will be shown on the display.
• It is necessary to select the search mode of devices with Bluetooth on a signal source
(telephone, notebook, smartphone, etc.). “HT-210” message will be displayed on the screen which
it should be connected to*.
• The “BLU” indicator lights continuously when connection is successful. If there is no connection,
“BLU” indicator will blink. In this case the system should be switched over to the search mode once
again (turn off and turn on Bluetooth mode)**.
• When the Bluetooth connection is active, you can control the audio source player with the remote
control or with buttons on the subwoofer front panel.
* * You might have to enter “0000” code to connect some models via Bluetooth.
** If an item has been already registered in the device list of sources, then the second search mode
activation is not needed. Choose only the item name and the “connect” command on the source.
ST-BY Mode
• To enter/exit this mode, press and hold down the volume control knob INPUT h on the front
panel or button m on the RC. When the HTSS is in the ST-BY mode, the display a shows the
current time.
Audio setting reset
• Press the RESET u button on the remote control to reset audio settings.
Notes:
• If the MSS is left unused for a long period of time, mind to switch it off with the POWER
switch (o, OFF position) and unplug the power cord q from the mains socket.
• To improve the sound quality, use the Line-Out port of your sound card.