Sven MS-2050 - Remote Control Overview

ENG
4
2.1 Multimedia Speaker System
m PC AUDIO INPUT: jack to connect PC
n AUX AUDIO INPUT: jack to connect linear input
o AUDIO OUTPUT: jack to connect satellites
Remote control
a INPUT: the MSS mode selection
b TREBLE-/+: treble level up/down
c TUNE+/-: manual band scanning (in the Radio mode)
d CH-/ : previous track (pressed short in the Player mode)
previous station** (pressed short in the Radio mode)
e BASS-/+: bass level up/down
f SW+/-: subwoofer volume level control
g 0-9: numeric pad
h REPEAT: player operation mode selection
i RESET: return to default settings
j CLOCK: current time display
k VOL+/-: volume level control
l SET: current time setting
m CH+/ : next track (pressed short in the Player mode)
next station
** (pressed short in the Radio mode)
n /AUTO: Play/Pause ( pressed short in the Player mode);
auto scan start/stop (pressed short in the Radio mode);
o MUTE: sound on/off button
p SLEEP: Sleep mode selection
q : On/Off button
r SAVE: memorize selected frequency (in the Radio mode)
Battery Installation
• Open the battery compartment on the back of the remote control.
• Insert the included AAA batteries.
• Close the battery compartment.
Notes:
• Use the RC at an angle no more than 30° at a distance of no more
than 7 meters.
• If the remote control does not operate, check the batteries or
replace the discharged batteries with new ones.
• Remove the batteries from the RC if you don’t intend to use it for a long time (more than one
week).
* The storage device must be formatted as FAT, FAT32. Memory cards SDHC class 10 or less can be used.
Connection of external hard disks other than USB flash drive is not recommended, otherwise it can cause
the MSS damage.
** The frequencies are switched if stations have been preset in the memory.
b
c
c
d
e
g
a
f
h
b
n
e
l
k
j
o
m
i
RESETREPEAT
SLEE PINPUT SAVE MUTE
TREBLE
AUTO
BASS
SE T
CL OCK
VOL
SW
1 2
3
4
5
6
987
+
-
+
-
TUNE -
TUNE+
CH+
CH-
0
q pr
Fig. 3. Remote
control