SVP SINGER C240 - Sewing Operations; Lowering and Raising Feed Teeth; Using the Presser Foot Lifter; Changing the Presser Foot

To Next Page

To Previous Page

Lowering Feed Teeth

You can lower the feed teeth by moving the switch at the

back of the free arm to the left. Move the switch to the

right if you wish to raise the feed teeth.

Note: The feed teeth will not raise immediately when the

lever is switched. Turn the handwheel one full turn or

start sewing to re-engage the feed teeth.

Presser Foot Lifter

The presser foot is lowered or raised with the presser

IRRWOLIWHU$,I\RXDUHVHZLQJRQKHDY\IDEULFRU

several layers of fabric, the presser foot can be raised

higher to make it easier to place the fabric underneath

the presser foot.

Changing the Presser Foot

Remove Presser Foot

Press the presser foot downwards until it disengages

from the presser foot holder.

Attach Presser Foot

3ODFHWKHSUHVVHUIRRWXQGHUWKHSUHVVHUIRRWKROGHU%

OLQLQJXSWKHQRWFK&ZLWKWKHSLQV'

Lower the presser foot lifter and the presser foot will

engage in the presser foot holder.

Note: Check that the presser foot is properly attached by

raising the presser foot lifter.