Swann DVR4-1000 - Basic Recording and Playback; Recording and View Management; Playback Operations

1010
IMPORTANT NOTE: The following instructions are for installing or changing the
hard drive. If your DVR4-1000™ already has a hard drive pre-installed disregard
these steps.
Installing or Changing a Hard Drive
Installing / Changing a Hard Drive in the DVR4-1000™
1. Ensure the DVR4-1000™ is unplugged and removed from mains power.
6. Replace the current Hard Drive and plug in SATA and power cables as shown
in step 5.
7. Screw in the hard drive to the bottom of the case.
8. Replace the top of the case.
9. Screw in the remaining 7 screws to the sides and top of the DVR.
2. Locate and remove the screws
indicated in the diagram. There are
7 screws in total.
4. Locate and remove the screws
holding the hard drive in place
shown in the diagram. There are
4 screws in total. Secure the hard
drive before unscrewing from the
DVR to avoid dropping / damage.
5. Remove the SATA and power
cable from the back of the Hard
Drive.
3. Pull up the top half of the DVR
case from the back and remove.
Remove
Remove