1
2
1. Connect the RCA end of the Video Cable to the to a Yellow Video
INPUT on the back of the TV Monitor.
2. Connect the BNC end of the Video Cable to the Video OUTPUT
connection on the back of the DVR.
3. Tune your TV to the correct input channel to view the DVR. Using your TV’s
Remote Control press the Input button until the DVR appears on screen. Most
TVs will label this button as Input, Video, Source, A/V, TV/AV, Line, Channel 0,
etc. If you are unable to view your DVR on your TV contact your TV’s manufac-
turer for assistance.
Back of TV
Back of DVR
Powering the DVR On/Off
To turn on your DVR connect the Power Adapter to the DC 12V input on the
back of the unit. To turn the DVR off unplug the DVR from the wall outlet or
power point.
If the DVR will not be in use for extended periods of time Swann recommends
unplugging the unit.
Auto-Recovery Feature
The DVR4-1000™ is equipped with an Auto-Recovery feature. Should a power
outage occur while you are recording the DVR will automatically resume record-
ing once power is restored.
To Next Page
Loading...
