Swann DVR4-Alert SW242-DAL - Motion Detection Configuration

User Manual
5.14 Motion Set
SENSITIVITY:
Use [
Up] and [ Down] button to
highlight the channel you want to modify
and press [
SEL] to adjust sensitivity of
motion detection on each channel.
High (1----------9, OFF) Low
When “OFF”, the channel will not
detect motion or trigger motion recording.
MOTION RECORD TIME:
This number indicates how many
seconds the motion detection recording
lasts after the DVR has detected motion.
MOTION ALARM TIME:
This number indicates how many
seconds the buzzer/alarm inside the DVR
will sound after the DVR has detected
motion.
CONT: Continuous alarm until press any
key is pressed when motion detected.
OFF: No alar
m
- 11 -
MOTION SET:
MOTION SET
MOTION RECORD TIME: 10
MOTION ALARM TIME: OFF
MOTION SET
PRESS (UP, DOWN), ENTER
(SELECT)
PRESS (MENU) TO EXIT
MOTION DETECTION SET
>CHANNEL 1 SENSITIVITY 4
CHANNEL 2 SENSITIVITY 4
CHANNEL 3 SENSITIVITY 4
CHANNEL 4 SENSITIVITY 4
CHANNEL 1 AREA SET
CHANNEL 2 AREA SET
CHANNEL 3 AREA SET
CHANNEL 4 AREA SET
PRESS (UP, DOWN), ENTER
(SELECT)
PRESS (MENU) TO EXIT
AREA SET:
Use [
Up] and [ Down] button to select the channel you want to modify and
press [
SEL] button to enter the sensitive area of each camera. The picture of the
selected channel is divided into 144(12*12) blocks, press [REW] to move left,
press [FWD] to move right, press[
Up] and [ Down] to move the cursor up and
down, press [
SEL] to set the highlighted block active or disabled.
When the block is transparent, it’s active or set to detect motion. When the
block is covered by a shadow, it is not active and motion will NOT be detected.
Make sure Record Schedule is set to Motion for the times required.